Installation of dryer vent

But where does the air go once it has stolen moisture from your socks, shirts, and hand towels? The ridged design of these ducts, however, tends to pose a fire hazard : In short, they trap lint.

For that reason, experts now instead recommend the use of rigid or semirigid hose; either can be found easily and purchased inexpensively in the diameter appropriate for your appliance for most dryers, the correct duct size is four inches. The shorter, the better. A straight path is the shortest possible route, but not always practical.

If, say, your dryer sits in the basement, then the hose needs to make at least one turn. From that maximum, deduct five feet for degree bends, and two and a half feet for degree ones. Now comes the most challenging part of dryer vent installation: putting a hole in the exterior wall.

In most cases, the opening must be four and a quarter inches wide for confirmation, consult the instructions provided by the manufacturer. My dryer works better than new, thanks for giving me back my time and my dryer.

I could smell this burning every time I turned on the dryer. You may have saved my family by removing the enormous amount of dry grass that birds had placed in my dryer vent for nesting. I will refer you to all my friends. God bless you for your quick response. Warwick, RI. Shop All Ranges. Explore Dishwashers. Shop All Dishwashers. Explore Microwaves. Shop All Microwaves.

Explore Cooktops. Shop Cooktops. Wall Ovens. Explore Wall Ovens. Shop Wall Ovens. Explore Freezers. Shop Freezers. Kitchen Accessories. Water Filters. Appliance Cleaners. Water Treatment. Product Registration. Warranty Information. My Appliances.

Schedule Service. Service Plans. Replacement Parts. Contact Us. Recall Information. Return Policy. Payment Options. Repair Or Replace. Article Summary. Method 1. Find the distance between your vent hood and dryer. Write down the measurement to use later. Put tape around the area of hose you need to cut. Set your vent hose on a smooth surface and extend it if necessary.

Then, use a tape measure to find an amount of hose equal to your previous measurement. Mark the area with a small amount of tape. Cut your hose using snippers. For safety, make sure to wear thick working gloves while cutting. Attach your hose to the dryer and vent hood. Hold it in place using a dryer tube clamp or a piece of foil tape. To use a tube clamp, unscrew the clamp to loosen it. Slip it onto the hose, line it up over the connecting seam, then tighten it back up.

Secure the vent hose with pipe straps. Make sure the dryer vent hose is free of kinks and bends. Then, fix it to the wall using screws and pipe straps. For every 6 to 8 in 15 to 20 cm of hose, use 1 pipe strap. Method 2. Measure the length between your dryer and vent hood.

Measure the path as if the hose were already assembled to account for any curves or bends. Record the measurement for later reference. Set your hose on a firm surface. Grab a piece of hose that is not yet assembled, meaning it looks like a sheet instead of a pipe.

Then, set it on a flat, sturdy surface like a wooden table. Slightly flatten the hose with your hands to make it easier to manipulate. Mark the area you need to cut.